How to Install the Wine Guardian Remote Controller and Sensor
Watch the official installation walkthrough for the Wine Guardian remote interface controller and remote sensor, covering mounting location, cable routing, connection to the cooling unit, and setup.
The remote interface controller lets you view and adjust your Wine Guardian cooling unit from outside the cellar, and the remote sensor lets the unit read air temperature at a point you choose instead of only at the unit itself. The video below shows how both accessories install and connect, so you can see what the job involves before you order.
Remote Controller and Sensor Installation
This walkthrough shows how the remote interface controller and the remote sensor connect to a Wine Guardian cooling unit. The video covers:
- Choosing the controller location. Mounting the interface outside the cellar where it is convenient to check conditions without opening the door.
- Placing the remote sensor. Positioning the sensor at a representative point in the cellar so the unit controls to the temperature that matters for your bottles.
- Routing the cable. Running the connection between the accessory and the cooling unit cleanly through or along the cellar wall.
- Connecting to the unit. Where the accessory plugs into the cooling unit's control board or connection point.
- Verifying operation. Confirming the display reads correctly and the unit responds to setpoint changes.
The written companion to this video is the accessory instruction sheet and your unit's manual, both linked from the manuals library.
What does the Wine Guardian remote interface controller do?
It gives you a display and control point away from the cooling unit, typically mounted outside the cellar, so you can check temperature and adjust settings without entering the room. That reduces door openings, which helps the cellar hold stable conditions.
Where should the remote sensor be placed in a wine cellar?
A representative location at bottle-storage height, away from the door, the cooling unit's direct cold-air stream, and any heat sources. The goal is for the unit to control to the temperature your wine actually experiences rather than the air right at the unit.
Can I add the remote controller to an existing installation?
Yes. Both accessories are commonly retrofitted to units already in service. The main work is routing the cable between the accessory and the unit, which is easiest when there is an accessible path through or along the cellar wall.
Is the remote interface compatible with every Wine Guardian model?
Compatibility depends on the unit's control system, so confirm the accessory part number against your model and serial number before ordering. Our team can verify compatibility from your unit information if you are unsure.
Do I need an electrician to install these accessories?
These are low-voltage control accessories that connect to the cooling unit rather than to line power, so many owners and installers handle them during setup. If the cable path requires opening finished walls or working near line-voltage wiring, a qualified professional should do that part.
Accessories Shown in This Video
All controls, sensors, and replacement parts with prices: Parts and Accessories.
Not Sure Which Accessories Fit Your Unit?
Send your model and serial number, and a specialist will confirm compatibility before you order.
This guidance is general and intended to help narrow the selection. Final sizing, installation design, electrical requirements, and configuration should be confirmed with Wine Guardian's official documentation and a licensed HVAC professional or qualified contractor.