Wine Guardian Split System Installation Video
Watch the installation walkthrough for Wine Guardian ducted split wine cellar cooling systems: evaporator and condenser placement, refrigerant line set, ductwork, and commissioning.
A ducted split separates the system into two parts: the evaporator section that conditions the cellar through ducts, and a remote condensing unit that rejects heat outdoors or in a ventilated space. That separation is why splits are chosen when there is no suitable indoor space to dump heat, but it also means refrigerant line work that belongs to a licensed HVAC technician. The video below shows what the full job involves for DS025, DS050, DS088, and DS200.
Split System Installation Guide: DS025, DS050, DS088, DS200
The walkthrough covers the decisions that make or break a split installation:
- Component placement. Where the ducted evaporator section sits relative to the cellar, and where the condensing unit goes outdoors or in a ventilated mechanical space.
- Refrigerant line set. Routing the lines between the two sections and why line length limits and proper charging are handled by a licensed technician.
- Ductwork to the cellar. Supply and return runs from the evaporator section, kept within the model's duct limits.
- Condensate and commissioning. Draining the evaporator section and what professional startup and verification look like.
The written companions are the Ducted Split Quick Start Guide, the full Split Manual, the spec sheet, and the condenser CAD drawing, all in the manuals library under Ducted Split Systems.
Who should install a ducted split wine cellar cooling system?
A licensed HVAC technician. Split systems require connecting and charging a refrigerant line set between the evaporator and the condensing unit, and that work is regulated and affects both performance and warranty. The homeowner's side of the job is usually limited to planning locations and providing power.
Can the condensing unit be installed outdoors?
Yes, outdoor placement is the typical reason to choose a split: heat is rejected outside instead of into the house. The condenser needs clearance for airflow and service, and placement should account for line set routing back to the evaporator section.
When is a split the right choice over a self-contained ducted unit?
Choose a split when there is no indoor space that can absorb the rejected heat, when the mechanical space is too small or too hot, or when you want the compressor noise moved outdoors entirely. If a ventilated indoor mechanical space exists near the cellar, a self-contained ducted unit is the simpler installation.
Which models does this installation video apply to?
The ducted split line: DS025, DS050, DS088, and DS200. The Pro split series (SP models) for commercial applications follows the same split architecture at higher capacities.
Ducted Split Models Shown in This Video
All split systems with prices and specifications: Ducted Split Wine Cellar Cooling Systems.
Planning a Split Installation?
Send your cellar dimensions and where the condenser could go, and a specialist will confirm sizing and configuration before you order.
This guidance is general and intended to help narrow the selection. Final sizing, installation design, electrical requirements, and configuration should be confirmed with Wine Guardian's official documentation and a licensed HVAC professional or qualified contractor.